The PhidgetLED 64 allows you to independently
control 64 Light Emitting Diodes. Each LED can have the current limit
set individually, and the brightness controlled from 0 to 100% within
that limit using pulse-width modulation. These LED outputs can also
be used to interface other devices that benefit from pulse width modulation
(such as buzzers, fans, and other small, simple electronics).
Most standard LEDs have forward voltages below 2.75 Volts, and can
be used with the PhidgetLED by simply soldering them to a connector-wire
and inserting the wire into any PhidgetLED board output. The forward
voltage will default to 2.75V, and the maximum current defaults to
20mA.
Comes Packaged with:
A 3018 - Mini-USB Cable 180cm
3021 - 16 Double Ended cables
A 12VDC, 2A Power Supply
A Hardware mounting kit
Note: Cut the Double Ended cables in half and solder the cut end to the LED. Check the Getting Started section of the User Guide for more detailed information.
|
