|
The L12 Linear Actuator is an axial design with a powerful drivetrain
and a rectangular cross section for increased rigidity.
The L12 actuator is designed to move push or pull loads along its
full stroke length. The speed of travel is determined by the gearing
of the actuator and the load or force the actuator is working against
at a given point in time. When power is removed, the actuator stops
moving and holds its position, unless the applied load exceeds the
backdrive force, in which case the actuator will backdrive. Stalling
the actuator under power for short periods of time (several seconds)
will not damage the actuator.
The linear actuator is an alternative to designing with gears, motors,
servos and linkages. The controller sees the actuator as a standard
RC servo.
Comes Packaged with:
Two mounting clamps
Two mounting brackets
Two rod end options: a clevis end and a threaded end with nut
Controllers:
This Servo can be used with the following Phidget
motor controllers:
1066 - PhidgetAdvancedServo 1-Motor
1061 - PhidgetAdvancedServo 8-Motor
|
